Ir a la página de inicio del Gobierno del Principado de Asturias

Datos del Documento

Utilice este identificador para citar o enlazar este documento: https://ria.asturias.es/RIA/handle/123456789/6661


Título: 3D printed millimeter wave receiver integrating a graphene subharmonic mixer and a diagonal horn antenna
Autores: Hadarig, Andreea
Ver Hoeye, Samuel
Vázquez, Carlos
Camblor, René
Fernández, Miguel
Hotopan, George
Alonso, Leticia
Las Heras, Fernando
Palabras Claves: Graphene subharmonic mixer
3d printed
Fecha Edición: May-2015
Editor: IEEE
Resumen: This work presents a millimeter/submillimeter wave frequency receiver integrating a graphene subharmonic mixer and a diagonal horn antenna. The device receives the RF signal through the diagonal horn antenna directly connected to the WR-3 input of the mixer. The desired frequency mixing performance is obtained using the non-linear behavior of a few-layer graphene film placed on a microstrip line gap. Using the internally generated 6th, 8th and 10th harmonic components of the input signal provided by the WR-28 standard waveguide in the 26-40 GHz the downconversion operation of the RF signal to a 300 MHz intermediate frequency is performed. A prototype of the receiver has been manufactured using high precision 3D printing technology. The performance of this device is characterized taking into account the behavior of the IF power in the 220-330 GHz band. Measured radiation patterns are also included.
URI: https://ria.asturias.es/RIA/handle/123456789/6661
Aparece en las Colecciones:Ingeniería

Archivos en este documento:



Archivo TamañoFormato
2015GSMM_Andreea_Hadarig_FinalPaper.pdf1,47 MBAdobe PDFVer/Abrir



logo

Todos los documentos en RIA están protegidos por derechos de autor.


Valid XHTML 1.0! DSpace Software Copyright © 2002-2007 MIT and Hewlett-Packard - Contacto